Yeethammer Flip Up Sight

prusaprinters

This sight is designed to replace the picatinny rail on the Yeethammer with a flip up leaf sight.It uses the same hardware standard as the Yeethammer, so you will hopefully have the right parts. Requires four 6x3mm magnets and one M3 screw approx 30-35mm long (I used 32 and haven't tested the others), plus some filament to include for the ‘fibre’ in the sight. Instructions:-Print all parts, you shouldn't need supports but may possibly want them for the magnet holes underneath the body.-If you like, you can paint the lettering in the sight with either paint or a marker, alternately you could use AMS or classic filament replacement to make it look nicer than painting.-You may need to bore out the hole in the Sight part with an M3 drill bit so that the M3 screw moves freely.-Slide magnets into the Sight first, you may need to play with polarity so that they don't push each other out. You could glue these in if too loose but I haven't needed to on mine.-Use your screw through the Body to hold the Sight in place, you can use the Nut pieces for a cleaner look (I put a heat set in one side of mine for easier hand screwing).-Superglue in the magnets to the underside of the body, placing the Sight in the right position to ensure the polarity is correct.-Insert filament into the ‘fibre optic’ holes, cut to the right size, and lightly melt both ends. Depending on tolerances you may or may not need to glue these in place.-Remove existing picatinny rail off the Yeethammer, and screw this one in place instead! I have also included greeble-free versions of the body and sight so that someone can do better/different greebling than me if they like. Or perhaps remix into something that can fit on a picatinny rail? Update 24/07/24 - While this is great for Mega XL darts and shotgun blasts, it doesn't work very well for high powered shots such as half-darts through a sniper-shell, the sighting is too low and you have to compensate. I wonder if I could do a flip up front sight as well?