Yaesu ft-2980r rails

thingiverse

Adapted mbrewha04 1-piece rails (itself adapted from IU1OPK's rails) to fit a Yaesu FT-2980r radio. It omits the middle risers. It's a couple millimeters short of protecting the very back corner parts of the radio, but at this length they can both just barely be printed as single pieces on a Prusa Mini+ when turned 45 degrees and without using any skirt loops. (Also, that radio is kind of a tank; these rails are more for protecting the front panel buttons.)Printed using settings referenced in the previous prints, 3-4 perimeter walls with 50-75% infill. I used PLA since I had it, probably better with something like ABS. PLA with 4 perimeters and 50% infill seems pretty sturdy, though.