Y-Shaft Clamp with sensor for Anet A6 Evolution Cube

thingiverse

This is a remix of the Y-shaft clamp for the Anet A6 Evolution cube type printer https://www.thingiverse.com/thing:2067818. The normal clamp (you may use three of them) remains unchanged. The new clamp features an additional terminal for a Y-end-stop sensor. You can use either the original Anet microswitch or the Makerbot mechanical endstop v1.2. Installation: For each clamp, you will need two M5x10 screws with washers and hammer nuts. Additionally, you will require two M3x8 screws with nuts. For the endstop, you will need 2.2x6.6mm spacers for the Makerbot switch or 2.2x13mm spacers for the Anet microswitch. Remarks: The Y-stop switch is now located on the outer side of the shaft, freeing up space for the Y-Bed Cable Chain (https://www.thingiverse.com/thing:3209864). On this outer side, there is the bed leveling screw, which can now potentially collide (see picture in the gallery)! The height of your y-bed will determine whether a collision occurs, but I had to change the screw from M3x30mm to M3x25mm.