Y-Shaft Clamp with sensor for Anet A6 Evolution Cube

prusaprinters

<p>This is a remix of the y-shaft clamp for the Anet A6 Evolution cube type printer <a href="https://www.thingiverse.com/thing:2067818">https://www.thingiverse.com/thing:2067818</a>.</p> <p>The normal clamp (you may use 3 of them) is unchanged.</p> <p>This remix clamp has an additional terminal for an y-end-stop sensor. For the sensor you can use</p> <ul> <li>the original Anet microswitch<br/> or</li> <li>the Makerbot mechanical endstop v1.2</li> </ul> <p><strong>Installation:</strong></p> <p>For each clamp you need:</p> <ul> <li>2x M5x10 + washers + hammer nuts </li> <li>2x M3x8 + nuts</li> </ul> <p>For the endstop you need:</p> <ul> <li>2x 2.2x6.6mm for the Makerbot switch </li> <li>2x 2.2x13mm for the Anet microswitch</li> </ul> <p><strong>Remarks</strong></p> <p>The y-stop switch now is on the outer side of the shaft. This has been done to free the space for the Y-Bed Cable Chain (<a href="https://www.thingiverse.com/thing:3209864">https://www.thingiverse.com/thing:3209864</a>). On this outer side there is the bed leveling screw as well which now can collide (see picture in the gallery)! Basically it depends on the height of your y-bed, but I had to change the screw from M3x30mm to M3x25mm.</p> <h3>Print instructions</h3><p><strong>Rafts:</strong> Doesn't Matter<br/> <strong>Supports:</strong> Doesn't Matter<br/> <strong>Resolution:</strong> 0.2mm<br/> <strong>Infill:</strong> 100%<br/> <strong>Filament:</strong> ABS, PETG, ASA</p>