Y Motor Base Mount & Belt Clamp (Tronxy P802)

prusaprinters

<p>I made these to reposition my bed motor on my tronxy p802e. My old motor was wearing out and I wanted to make room for a better more powerful motor. Also, I wanted a better belt clamp that would make sure the belts were fairly level.</p> <p>The motor mount screws down to the board that my printer is strapped down to. Thus, I really could have removed the brace you see in the bottom of the motor images. I moved the motor to the right a few mm and a little lower under the bed. Lowering the motor made more room for the insulation under my bed as it was rubbing just slightly before.</p> <h3>Print instructions</h3><h3>Category: 3D Printer Parts Print Settings</h3> <p><strong>Supports:</strong> No</p> <p><strong>Notes:</strong></p> <p>Print everything in the orientation it comes in as. Petg is probably best for all parts. I did use eSUN ePC on the belt clamp for extra extra heat resistance just because I had it handy, but petg or abs would be fine.</p>