xyz daVinci Pro - External Spool Hanger

thingiverse

Thanks to ChatToBrian for the original design! Primary changes were made to support hanging the CEL Robox spools I own: A slot was added to the top of the spool bar to hold the CEL spool's hub close to the printer. The spool bar itself was slightly narrowed (top-to-bottom) and its lower radius was increased at the end to accommodate sliding the CEL Robox spool onto the support bar. An additional support was added below the spool bar to support the lower portion of the CEL spool hub. After printing, I realized that this support needed to extend further from the printer, so my picture shows a makeshift fix, but the STL file has the additional protrusion incorporated. The incorporation of a filament filter chamber is another change where filament passes through the spool hanger. Note: Four thin supports were added to the filter chamber that should be cut away after printing. If I had taken a closer look at the filament's path through the hanger and into the printer, I would have put the filter chamber at a more upward angle, but this should work.