XYZ daVinci Jr - NFC Reader 2020

thingiverse

*** Update I've updated STLs with the right part orientation, making them ready for printing. If you've downloaded previous v3 - nothing to worry about, as it's the same part, only rotated. If you use an external spool holder and want to swap NFC tags more easily, this might be your solution. Also, what's the point of keeping that bulky internal spool holder if it's not being used?! I tried to make it as non-intrusive as possible so it fits 2020 alu extrusion width and sits right in the corner to give you more space inside your printer. Fitting Instructions: Take apart your spool holder. Fit all NFC reader electronics into the new housing (I've added a bottom photo of the housing to make it easier to understand how to position electronics). Slide in the bottom piece to isolate electronics from the 2020 alu extrusion (I've simply put electrical tape, this part was never printed but should fit, in theory). Turn housing sideways to fit in that "hook" and twist to lock in place. When locked, just slide it over corner-bracket. Connect cable and secure it with last part aka clamp. It holds reader housing in place and tucks down the cable. Print Settings Printer: XYZ Printing da Vinci Jr Rafts: Doesn't Matter Supports: No Resolution: 0.2 Infill: 30%