xyz Da Vinci Spool Holder

thingiverse

Print Left and Right assemblies with two screws. Prints without support required. For more information, see instructions below. This device has worked great for over 100 hours without feed issues reported. Supports printing multiple spools at the same time. Most spool sizes will fit, still allowing access to open the back panel. Instructions: Print all four files provided. Attach the assembly to an existing xyz printer structure. Tighten screws until the spool holder is firmly in place. For optimal results, use 1-inch PVC with a thicker wall tubing design. The design mirrors the original object, reversing the screwing direction. Note: This model has been successfully tested on one version of the printer (1.0A), but further refinements can still be applied. A potential improvement could include reducing material usage and enhancing contact points between the assembly and the printer case.