xyz 30 40 60 mm test cube cr-10 comparison & jerk acceleration test

thingiverse

Fed up printing cubes and forgetting what was what. Don't forget to also make them bigger in the slicer. Make sure it's set up correctly on your bed. Printed on the CR-10 with Micro Swiss 300 hot end using standard Cura profiles "Cura 3.04" for those speeds of 30-40-60. Things were adjusted, and retraction was set to 2mm - the Micro Swiss doesn't like much or seem to need it. Printing PLA at a temperature of 215 with a layer height of .2mm and 10% infill. Z seam is on random every time. Everything else is standard profile. ******************* The last pics in white, 30mm cubes have been altered - jerk and acceleration settings were adjusted in Cura. Now there are no lines, it's super smooth with no ringing or banding, even on the super sharp corners. "Frigging Perfect." Jerk was reduced from 20 to 8, while print acceleration was bumped up from 500 to 800 - seemed better that way. Adjusted in Cura 3.04. Tried as low as 400 with even better results, but longer print times. If you have a CR-10, please post your prints so I can see how they compare side by side after swapping the hot end.