xtool RA2 Extra Long Chuck Attachment

thingiverse

An extra long attachment for the chuck attachment that comes with the RA2. Note: This was designed to support a candle jar with a very heavy base (that caused it to move during engraving (even when supported with the rollers). That glass jar design slightly tapers in down the jar so this does as well. If you want something flat, you could simply wrap some tape around the ends of equal wraps to thicken it back up. Recommended to print solid using a resin printer. Not tested with FDM however it should work if your printer is dialed in. Do not tighten the screws too tight or you will probably crack the resin. If you can, print with a less brittle resin. If you are not aggressive tightening the bolts even standard resins work fine.