XT60 rear support for Peon230

thingiverse

I created this support to secure a fixed XT60 plug on my Peon230 quadcopter. This design could be adapted for other quads as long as the screw spacing is 17mm apart. To assemble it, you'll need two M3 nuts and the arms screws from the bottom. The M3 screws should be around 15mm long, but you can use longer ones up to 17mm if necessary. The hole in the support is a bit loose for a bare XT60 connector, so I added a heat shrink sleeve to create a friction fit. As shown, I doubled-taped my FS X6B receiver on top of the support and secured it with a zip tie for extra stability.