XT60 mount

thingiverse

This is an improved XT60 mount that's been streamlined from the original two-piece design found at http://www.thingiverse.com/thing:702525. I took the initiative to modify this model into one piece, eliminating the need for nuts and bolts in the process. This change offers some clear advantages over the source material, but also introduces a few disadvantages that I'll discuss below. The modified XT60 labels on my model provide a secure hold for the female connector, allowing it to be easily integrated with other components as needed. You can use this approach to attach the female connector directly onto any given part, providing a seamless connection. The single-piece design of my mount makes it much simpler to place in any location where support is required. However, one potential drawback is that pushing the connector into position can be slightly tricky due to its small size and tight fit within the holder. Once you've managed to secure the connector, removing it from the printed part without causing damage can prove to be a significant challenge as well. During my testing phase, I opted for full infill to ensure maximum structural integrity in the small print area of the holder. However, given its compact nature, this wasn't strictly necessary; instead, thicker walls would have sufficed for creating a strong bond between the holder and connector. A perimeter width of 1mm is more than sufficient for securing this connection without sacrificing too much print resolution or structural integrity.