XT60 Connectors Plus Strain Relief

prusaprinters

<p>These are my take on some XT60 connectors.</p><p>They are made to fit 3.5mm (4mm OD) connectors. They should be press fit, I had to use a small vice to press mine in place. On the male connector, I added a bit of super glue after to hold them in place as there is less area to hold them in place.</p><p>I tested my prints with some generic XT60 connectors, and both fit the standard connectors with no modifications.</p><p>I printed mine in Polymaker PC @ 0.2mm and they handled the heat of soldering easily.</p><p>Print with the solder end to the printer bed, no supports needed.</p><p>I printed the strain relief in TPU @ 0.2mm, and they slide on of the wires after soldering.</p><p>The strain reliefs have a small rim that fits into the area around the contacts on standard XT60 connectors. Make sure you print with this rim facing up. No supports needed. Note: You may have to trim off this rim when using these with my XT60 connectors.</p>