XT60 combine two-into-one Y connector, parametric

thingiverse

Can connect two XT60 in series. No additional support needed; one file requires a 180-degree rotation before printing. The bottom section can be used as a jig to hold them together at the correct positions when soldering, allowing for test fitting of the top part and possibly resoldering it into different positions or bending wires. Once satisfied, fill the inside with hot glue or regular glue and press the pieces together. A good initial estimate for the wire between the bottom and top is approximately 13mm, soldered to the bottom; try to fit the pieces together and trim away excess wire when necessary. After testing, if it's 1-2mm too high or low, resolder by eyeing the adjustment or bend the wire if the difference is insignificant. Only when the bottom and top match well should you solder the S shape as a final step, making adjustments more challenging due to increased rigidity.