XSR-E Mount for RakonHeli 66mm Brushless Whoop

thingiverse

This design was specifically created for the RakonHeli 66mm brushless whoop and XSR-E SBUS receiver. A super clean build without components being stuck together by glue is what I aimed to achieve. This design slip-fits over the RakonHeli provided standoffs, allowing you to mount using the mfg. hardware. The bolt pattern for the XSR-E is 15x15mm, which differs by 1mm compared to the 16x16mm FC/ESC stacks. If you haven't seen the XSR-E, click on this link: it's an affiliate link, so if you like the design and recommendation, help out a friend and buy through the affiliate link. https://www.banggood.com/Original-FrskyEACHINE-15x15mm-XSR-E-D16-2_4G-16CH-ACCST-Dual-Receiver-Compatible-SUBS-CPPM-Output-p-1148143.html?p=0Q242226707462015095 If you're looking for a clean stack on your RakonHeli 66mm whoop, this is what you need. Some tips to keep in mind: -The model can be oriented as-is or rotated 180 degrees on the X-axis. Depending on the orientation, you may have to add additional supports. -Make sure that you print with a layer height between .1-.15mm. The smaller the better. -Use supports that fill at least 50% of the supported area. -Use any type of flexible filament (TPU, Ninjaflex, etc). -Use slower than usual print speeds. This was printed at 2200mm/min X/Y access, with 1200mm/min on the Z. If there are any questions or comments, leave them below and I'll get back to you. I can print and mail for a small fee. Send a message if interested.