Xmod Modified chassis for modern electronics

thingiverse

This custom Xmod chassis is designed to simplify the installation of modern electronics. It was tailored around specific parts, which are listed below, but adjustments may be necessary if you use different items. Furthermore, this design focuses on the medium length chassis configuration, and the short and long options were not included. The Fusion 360 files are provided to assist with any changes that may be required. All components were printed at a layer thickness of 0.20mm. Key components include: Front brace: supports are necessary, pause the print at layer 20 to switch colors (optional) Rear brace: no supports ESC strap: no supports (you could skip printing this entirely and secure ECS with hot glue instead) ESC & servo holder: supports are required Chassis: two printing options are available: Print with a logo inlay: Bottom logo: print without supports, pause after layer 2, stop the print when paused, change colors, then print "chassis-bottom logo" chassis-bottom logo: print with supports and adjust the z-hop retraction to 0.5mm No logo inlay: chassis-no logo: print with supports Required components include a Hitec RCD 35065S servo available on Amazon at https://www.amazon.com/Hitec-RCD-35065S-HS-5065MG-Feather/dp/B001GR7YXC A Shaluoman RC ESC 20A Brush Motor Speed Controller with Brake is also required and can be found on Amazon at https://www.amazon.com/Shaluoman-Brush-Motor-Speed-Controller/dp/B07GSVS8D2/ref=sr_1_4?dchild=1&keywords=20a+rc+esc+brushed+motor+speed+controller+with+brake&qid=1589293440&s=toys-and-games&sr=1-4 A 7.4V 300mAh 20C Lipo Battery for WLtoys F959 can be purchased on Amazon at https://www.amazon.com/gp/product/B07MW5BRZS/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1