XL Finger Grip Arm-Wrestling

cults3d

Niche of a niche, arm wrestling x 3D printing... Compatible with the Mazurenko handle, but we usually just use a carabiner, some webbing, a buckle / tie-down strap, and some foam for padding. If it's too slippery, you can add some grip tape but we haven't found this to be the case :) A thicker nozzle helps with strength, stability, and prints faster! X: 73.6mm Y: 115mm Z: 140mm I would buy some grip tape (like what they use on the top of skateboards, but say, 10cm wide) to wrap around the handle. I found that adding knurling to the design did not help with the grip much, especially with a 0.8mm nozzle. However, grip tape helps a lot! It's up to you how much grip you'd like :)