Xiaomi Wowstick Case

cults3d

A simple Xiaomi Wowstick case - holds the wowstick 1F+ with a bit still installed (because i'm too lazy to take the bit off every time :) ), plus the three tool tubes it comes with. I didn't add in space for the cable or any other accessories, as I tend to charge it at home, and carry minimal equipment when out in the field. Plus microUSB chargers are everywhere anyway :D Print both halves, lightly sandpaper the backs of four pairs (8 total) of 8x3mm magnets (sanding them gives better adhesion), and glue them into the recesses in the case with super-glue (cyanoacrylate) or similar (two-part epoxy, gorilla glue etc). Tolerances should be good for pretty much any printer. No supports needed. 0.2 layer height or less for better accuracy on the curves. 20% infill recommended for cleaner finish, and 3 perimeters for strength, but optional.