Xiaomi MiJia m365 - Rear wheel mudguard

thingiverse

**Mudguard for Xiaomi MiJia M365 Scooter - Rear wheel** 1) Print parts on your 3D printer. 2) Print PDF on A4 paper, stick it to 1.5-2.5 mm rubber sheet, cut along the edge. 3) Prepare all parts for bonding including rubber: sand and degrease. 4) Glue the parts together using instant glue - gel! 5) Sand and degreas the inside of the wing 6) Use a Hot Melt Glue Gun to attach mudguard. Recommendations: 1) Use a Heat Gun to detach mudguard. Tried on a series of scooter over No. 00135000. (Be careful, do not overheat the wing!) 2) It is strongly recommended to install any support for the wing of the scooter when mounting the mudguard, in view of the appearance of additional load and avoid breakage. This design is not the development of the manufacturer of the scooter and is not an integral part of the scooter necessary for installation. Remember don't go crazy, it's your scooter after all, you have no one but yourself to blame if something goes wrong.