Xiaomi Mi Watch Magnetic USB-C Charger

prusaprinters

<h3>Required hardware:</h3><ul><li>8x 1.7x4 self tapping counter sunk screws</li><li>1x <a href="https://www.amazon.de/Adafruit-USB-Breakout-Board-Downstream/dp/B07Y3BBYVG">Adafruit USB-C breakout</a></li><li>2x <a href="https://www.amazon.de/Yibuy-Vergoldet-Kupfer-Pogo-Pins-Wasserdicht/dp/B07FPMQ6ZC/">Pogo Pins 2mm</a></li><li>2x cube magnet 5x5x5mm</li><li>some silicon cable</li></ul><h3>Assembly Instructions:</h3><ul><li>Put the magnets on the back of your watch to make sure you got them oriented the right way. You may use some heat to push them fully into the part.</li><li>The pogo pins need so be placed approximately above the holes and are then melted into the part by using a soldering iron. Be careful to not apply too much pressure or to melt the entire part :-).</li></ul><h3>Available Files :</h3><ul><li>mi_watch_charger_bottom: base part to mount all the hardware</li><li>mi_watch_charger_top: cover to hide all the mess inside</li></ul><h3>Printing Instructions</h3><ul><li>Prusament PETG Urban Grey</li><li>layer height 0.15mm</li><li>No support</li><li>No raft</li></ul><h3><strong>Feedback Appreciated</strong></h3><p>Please give feedback and post your makes. Any suggestions and improvements are appreciated.</p>