Xia Legends of a Drift System (plus expansion) coin holder

thingiverse

A coin holder specifically designed for Xia: Legends of a Drift System, encompassing both Kickstarter coins and Embers expansion. The Kickstarter coins are valued at 2,000Cr each and bear an orange hue. They remain available through various platforms such as Amazon or eBay for those seeking to acquire them. Please note that this is an unofficial creation, not endorsed by Far Off Games or the game's designer in any manner. In my own gameplay experiences, I found it necessary to separate the coins across the table using cups, jars, and plastic condiment containers. However, I had to constantly return these coins to their bag (for Embers' 10x 1,000 Cr coins and the Kickstarter 2,000 Cr coins) or replace them in the inner box liner/organizer, which lacked sufficient space for the expansion or the 2,000Cr coins. To address this issue, I designed a coin holder that divides the coinage evenly between each side of the table. This design also enables the storage of coins within the game box. You will need to print one lid and two holders, as each unit is designed to hold half the total coinage from both the base set and the expansion, including the 2,000 Cr coins. There are two versions of this holder available: -- For a total of 40x1,000 Cr, 10x2,000Cr, and 10x5,000Cr coin sets (version name: XiaCoinHolder-20x1k-5x2k-5x5k) -- Or for 40x1,000 Cr, 20x2,000Cr, and 10x5,000Cr coin sets (version name: XiaCoinHolder-20x1k-10x2k-5x5k) The naming indicates the total number of each type of coin each holder can accommodate ("10x" holds ten of a specific type). The version depicted is an earlier design variation, distinguished only by larger and more visible coinage markings. These markings were enhanced to eliminate the need for using pens to make them legible. This design is suitable for FDM printing as shown; however, it's recommended that you increase the x & y dimensions of all parts by about 102% in your slicer to ensure a proper fit for the coins. In my own print, I discovered that the bottom of the containers was slightly too small, causing the coins to not lie flat. Scaling up these dimensions should resolve this issue, provided you apply the same adjustment to the lid.