XGIMI MoGo 2 Pro case

prusaprinters

I needed a case for my XGIMI MoGo 2 Pro portable projector, and decided to print one. It works pretty well and has protected the projector on several camping trips. However, I would not recommend relying on this if you're planning on dropping your projector off of a cliff or white-water rafting with it.You will need to print:From this model:top.stlbottom.stlFrom zx82net Customizable Rugged Waterproof Box:2 hinges2 latch arms2 latch camsYou will also need some additional hardware:8 20mm M3 bolts8 M3 nutsFollow the directions on the zx82net model to assemble. I found that the holes were very tight, but I was able to install the bolts without too much trouble. I printed with 10% infill and 2 perimeters so it's a little bit flexible.The fit is very snug so if you're not confident in your printer's dimensional accuracy, you could print a thin slice of one of the sides to make sure it fits. You could also slightly enlarge the case and line it with some soft fabric, but I haven't found that to be necessary.When storing the projector, you should place it so the lens faces the cutout on one side- this will protect it from possible scratches.