Xcarve Dustboot to supergrade Z by TBC

thingiverse

You will require two 45mm M5 screws with back nuts for the 20/20 rail. Additionally, you'll need two 20mm screws with nuts for the block. To mount these components, drill out the original X-Carve dust boot brackets and secure them in place. The print settings used were 265C for the extruder temperature and 100C for the bed temperature, at a resolution of .16mm. This configuration allows for successful printing without any support material. Please note that due to the offset design of the dust boot, approximately 15mm forward from its original position, you may need to modify or remove the small clear baffle held in place by four screws. If you still intend to use this baffle, it's recommended that you either cut or print a new one to accommodate the changed configuration. Alternatively, removing it altogether is also an option, as the user has done in their setup with a large dust collector, finding that it hindered performance more than it helped.