XC- Amarok Clamp

grabcad

This is the 4th and final iteration of my Amarok triple tree clamp. Realistically, it's probably the 5th or 6th major design change but it was a flurry of SolidWorks activity this afternoon so I'm calling it 4. It continues the same overall design of V4; prominent display of the Amarok logo on the 'dashboard' of the (motor?)cycle. This one is stronger with the addition of the front braces, as well as incorporating the Amarok name and the claws of the paw logo. It should be somewhat easier to machine than V4. It weighs 596 grams and withstands a 75lbs down force on each side while being supported upon the center hole. The smallest inside radius is 3mm (except for some 1mm radii on the top side of the part where the paw pads meet the boss for the center bolt). Good luck to everyone who submitted an Amarok clamp, there are some stunning entries. I almost didn't enter but this community serves as more of an inspiration than a deterrent, thank you all for that.