Xbox360_One_Hand

prusaprinters

This print was designed to make it easy to control the joysticks if you have one hand. I designed it so people with the prusa mini will also be able to print it this was also was designed to fit an Xbox 360 controller but it should work with other controllers. To assemble put the two long parts inside of each other adjust to your desired height and then place the locking pin in the whole of your desire height. It will be a bit rough at first but after a couple uses it should smooth out and I was able to assemble it with one hand but it might not work for every single person. It is also best to put something on the base so it doesn't move around a lot. To print automatic supports will be fine and PLA works great but PETG is amazing.