Xbox Series X Wall Mount

thingiverse

This is a wall mount for the Xbox series X if you want it off the floor. I added some tiny silicone bumpers from Home Depot in the corners to keep it from vibrating the wall (not sure if that's a problem). The mount comes in 3 pieces so no supports needed and screws together with regular M3 button head screws and nuts. I used black ones so they blended into the black PLA and xBox case. For the wall I used 3" Deckscrews as they are tougher than regular sheetrock screws. I made two of them go into a stud and the other 2 are in self-tapping anchors. Feels very solid. Of course the elephant in the room is: is PLA sufficient? (*OMG PLA isn't structural, etc, etc*). I did it in PLA (which actually has very high compressive strength) and honestly nobody better be beating on my expensive console. One help is by printing in separate parts the layer lines are on axis with the load so this is very strong (I used 4 perimeters) You could glue the top to the braces but honestly unless your house has less than 1g of gravity the xbox itself should hold that in place with the bolts. ## Tools Note I used a very long screwdriver bit on my drill to drive the screws as it's a long reach through the holes in front of the brace. For leveling you can put a bench level across the flat part once assembled and up against the wall and then mark your holes. As always I have included the STEP file If you want to mod this (any real CAD package can import this - obviously it is metric since it was for 3D printing) As an add-on I might add some cool looking inserts on the sides (just for aesthetics)