Xbox One Controller Trigger Stops

thingiverse

This print flies, but trust me, it's effective. All you gotta do is pry off the side panel of the controller - it's the one I show in the second pic. Wherever you want the trigger stop to go, that's where you'll take it down. Two clips hold it in place; a little wiggling with your fingernails will have them come loose fast. Don't be shy, give it a tug and see what happens - or better yet, grab a screwdriver to make things easier. Once those clips are gone, slip the plastic insert between the trigger and its original stop, which comes equipped with a rubber pad. It might rattle around at first, so tack it in place for good measure as I show you in the first pic. Close up the side panel, and voila - you're done! Print Settings Rafts: No Supports: No Resolution: 0.2 mm Infill: 5% Notes: You might get away with printing your first layer a bit too thick. This would create a lip, making it stick nicely to your controller without needing any tacky tape at all - but hey, no worries if you don't!