Xbox One Controller Holder

prusaprinters

I like my controller to be stored out of sight, but still reachable from my chair. I recently discovered a model that would hang the controller by the joysticks. However, there is speculation that this will induce drift into the sticks after time. I liked the idea of the controller being under the table so I crafted this up in fusion. Insert controller and allow it to snap in, the bar inside should slide between the start and select buttons. To remove I push the lower portion downwards slightly and pull the controller out. I recommend using PETG as the holder needs to flex in order to allow the controller to slip in and out. I printed it sideways with supports on build plate. Mounted with screws. I made the holes on the bottom big enough to fit an average sized fillips driver. I uploaded a .3 layer height gcode for the mk3 and a .25 gcode for the mini.