Xbox Logo 3D

thingiverse

Three versionsSeparate parts, print separately and hot melt glue togetherElevated XDepressed XPlease post makes, especially 2 color.Printed on Ender 3S1, Gnvtntp Tri-Color Coextrusion Silk Red-Green-Blue Filament and Geeetech Silk silver.I played with seam hiding in Cura, see below for recommended settings at least for my Ender 3S1. I recommend going through each seam option and doing a preview with 'starts' checked to see where each layer begins, it's the white dots. Play with the seam settings until most of the 'starts' are on an edge or corner. Smart hiding was one of the worst options, many starts were in a smooth area, go figure.Recommended settings for all:Top/Bottom Pattern: concentricinfill: lightning 10%layer height: .12mmadaptive layersRECOMMENDED SEAM HIDING SETTINGS FOR EACH VERSION so most of the starts are on an edge:Settings for XBOX_Depressed_X and XBOX_Elevated_Xz seam alignment: sharpest cornerseam corner preference: expose seamSettings for XBOX_Outside_only,z seam alignment: user specifiedz seam x 110z seam y 137seam corner preference: noneSettings for XBOX_X_onlyz seam alignment: user specifiedz seam x 110z seam y 118seam corner preference: none