Xbox Headset and Controller Wallmount

thingiverse

Material: PLA or PETG Settings: At minimum, three walls are necessary with a 0.4mm nozzle diameter since this will be a load-bearing part. A recommended minimum of 15% infill is required; however, infill does not contribute much to part strength. Whatever speed your printer can handle is acceptable. Increasing flow rate or line width may result in a stronger bond but reduced dimensional accuracy. No supports are needed; slice and print the Xbox logo face down. Keep in mind that any imperfections on your printer bed will also cause defects in the final part. Assembly: Acrylic glue or wood glue should be applied to the Xbox plate, then secured to the wall plate. Allow any physical glue like wood glue to dry for at least 24 hours before use. Use clamps. Twenty-five pound load-bearing drywall screws should be used to mount the plate to a wall.