Xbox Controller Trigger Mod

prusaprinters

<p>All files are uploaded in their best printing orientation. &nbsp;No supports are needed and I suggest printing the covers with a .15mm layer height for added strength.</p><p>This style of mod utilizes the Xbox controller battery cover as its source of mounting. There is no gluing or modifying of the controller necessary. just replace the existing cover with one of the 6 I have supplied and add the triggers that suit the style of modification you need.</p><p>All files are labelled for the type of configuration they are meant for. &nbsp;there are 3 different covers for top down play, Right Hand play, and Left hand play. Also each cover has an additional file if you require the controller to be supported because you do not have the hand strength to hold onto the controller.</p><p>The table mount has knurled nuts that will fit a 6mm screw and nut. &nbsp;the mount and the covers are ridged where they intersect to add a friction fit once the screw is tightened to increase the grip and not allow the controller to move while playing.</p><p>The left hand and right hand triggers will need to be installed before the cover is attached to the controller. they have a snap fit in the middle that will guide the trigger and not allow it to travel to far and pop the cover off. the regular triggers can be used with any cover and can be installed after the cover is attached to the controller from the back. &nbsp;Just push down on R1/L 1 and slide it through the slot. &nbsp;The regular triggers are held in by the pressure of R1/L1 and R2/L2 and rotate about the center or the arm that extends off the cover.</p>