XBOX Controller Soft Joystick Covers

prusaprinters

I've long had issues with rubber wearing off of XBOX controller joysticks after a period of time. I created this model to replace the worn away rubber with a TPU cover. Print InformationMaterial:  TPU 95A*Nozzle Diam:  0.40mmLayer Height: 0.10 mm*Be sure to verify that the print bed you plan on using is appropriate for TPU. Installation InstructionsCut away any remaining rubber with a utility knife.Clean the area with a dremel wire wheel (Optional, but useful to be sure any of the old material is gone).Clean joystick surface with IPA. Be sure surface is free of dust or debris.  Apply super glue to the top surface. Slip the two printed halves of the soft cover onto the joystick. Hold halves in place for approximately 30 seconds or until super glue cures.