XBox Controller Replacement Thumbstick Rubber

prusaprinters

Simple part to print, to replace the thumb stick rubber on XBOX controllers.  Print in TPE or TPU, stretch over.  I printed with Fuzzy Skin at 0.3x0.3mm – this is my personal taste.  I did use supports on build platform only, and printed it with the bottom to the platform.I also used variable layer height, with very thin layers for the top section, so that the fuzzy skin was everywhere.  I also printed with enough walls to make it 100% infill effectively, and used some heat to make it flexible enough to stretch over.   This is definitely personal taste again, but I wanted it to be solid like the original, and not squishy.