XBOX 360 Controller Desk Stand

thingiverse

Initial Foray into Designing a Xbox 360 Controller Stand. This makeshift desk stand effectively holds the controller in place, and it's relatively easy to slide the controller in or remove it whenever you need to. To avoid any accidental knocking of the controller out, make sure to apply a bit more weight on top of the base to prevent wobbling. However, I do notice that the Hex Pillar comes up just a tad short of reaching the center of the base hole. Thankfully, once secured with some adhesive, it manages to stay put pretty well. The upcoming iteration is likely to address this slight inaccuracy by including additional holes below the base plate to accommodate weights or small nuts, like M12 sizes for added stability, possibly substituting 5 pound coins too for an exact match. Moreover, there will be adjustments made to ensure a tighter fit at the center of the Hex Pillar. Details to Follow Design Process Utilizing Fused Deposition Modeling with PLA In terms of production, it's advisable to start off by printing this model at a relatively low first-layer speed of 30%. The following layers may then be completed using normal settings with a nozzle diameter of 0.4mm