XBox 360 controller analog stick caps

thingiverse

I am thoroughly captivated by this outstanding project! The level of detail and design choices that have gone into it are truly impressive, and I must commend philbarrenger on their exceptional work! I had the pleasure of creating two custom caps for my PS4 controller, but then I thought to myself, "Why stop there? What about my Xbox 360 controller?" (I use it extensively with my PC). The diameter of the PS4 analog stick tops measures 0.7", whereas the Xbox 360's is slightly larger at 0.73". To avoid overstretching the PS4 caps and potentially damaging the rubber coating on the sticks, I decided to remix my two favorite designs for a better fit. This project was designed with TPU semi-flexible filament in mind (or even TPE). The FreeCAD v0.16 source files are included, allowing users to make adjustments as needed. If you're able to bring this design to life, please share your creations in the "I Made One" section! A notable point is that the wide cap may not align perfectly with the "X" button, but it can still get in the way. If I were to revisit and improve this design, I would make sure to address this issue. Print Settings: Printer: Anet A8 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 30% Notes: This project was printed using an Anet A8, which is essentially a Prusa I3 clone. The design process involved the use of FreeCAD v0.16. I am thoroughly captivated by this outstanding project! The level of detail and design choices that have gone into it are truly impressive, and I must commend philbarrenger on their exceptional work! I had the pleasure of creating two custom caps for my PS4 controller, but then I thought to myself, "Why stop there? What about my Xbox 360 controller?" (I use it extensively with my PC). The diameter of the PS4 analog stick tops measures 0.7", whereas the Xbox 360's is slightly larger at 0.73". To avoid overstretching the PS4 caps and potentially damaging the rubber coating on the sticks, I decided to remix my two favorite designs for a better fit. This project was designed with TPU semi-flexible filament in mind (or even TPE). The FreeCAD v0.16 source files are included, allowing users to make adjustments as needed. If you're able to bring this design to life, please share your creations in the "I Made One" section! A notable point is that the wide cap may not align perfectly with the "X" button, but it can still get in the way. If I were to revisit and improve this design, I would make sure to address this issue. Print Settings: Printer: Anet A8 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 30% Notes: This project was printed using an Anet A8, which is essentially a Prusa I3 clone. The design process involved the use of FreeCAD v0.16.