X5S FANG OEM fan duct assembly - easy & sturdy print

thingiverse

Here is the rewritten text: This is the carriage plate for the Tronxy X5S, allowing you to mount all fangs and fang remixes from the CR10 version of the fang assembly I designed last year. If you have downloaded this thing, you will also need a fang of your choice and the 40mm fan duct, both available on the CR10 page following this link: https://www.thingiverse.com/thing:2763931 There are several options to choose from, including a 4010 (stock fan) fang, a 5015 fan fang, a dual 4010 fan fang, a dual 5015 fan fang, and a 40mm axial fan fang. You must flip your X-end switch upside down (see pictures). It's best to print the parts that touch the cold end of the hotend in ABS. I used a 100% PLA assembly for months on my CR10 without any issues, but you can print the actual fang in PLA if you prefer. A notice: I had to shorten my heatbreak on the X5S because the spacing was off compared to the CR10. My heater block and nozzle were hanging much lower, so the fang airflow wouldn't be pointing at the tip of the nozzle. You should check if this is also the case for you. The gap between your heater block and cold end (heatsink) should be within 4mm. I have uploaded an optional dual 4010mm fang that fits the Tronxy X5S series. This is not a stock design, as it requires an additional 4010 fan. You can find this remix in the remix section or on the CR10 assembly page (see link above). The one in the remix section only fits the Tronxy X5S, while the one on the CR10 page fits both CR10 and X5S series. Update: I have added an alternative version of the carriage plate for those who have their belt setup reversed (see comments), so that the carriage plate wouldn't interfere with the belt.