X4R Bind Button Protector

thingiverse

X4R Bind Button Protector. Small builds like the Atom V2 require precise tolerances, which means you must depin your receiver and risk the canopy pressing against it, potentially triggering the button during flight - a scenario you'd rather not encounter. A thin cover on top prevents this from happening by providing a snug fit that requires only a light press to clip in place. The design has undergone numerous revisions to achieve the perfect balance of protection without compromising usability. If you create this protector, please upload a photo under the "Made" section so others can appreciate your work. **Print Settings** * Printer: Wanhao v2.1 * Rafts: No * Supports: No * Resolution: High / 0.1mm * Infill: 100% **Notes** This print is optimized for a 0.4mm nozzle, with walls printed one layer thick for maximum quality. To achieve the best results, use high resolution and print upside down to avoid supports. Due to its tiny size, you may need to slow down your printing speed - I achieved great results at 80% speed (approximately 40mm/s). Print time is remarkably short, taking under 5 minutes even when slowed down. **Design Process** This design was created using Openscad and calipers for precise measurements. Multiple prints were made to fine-tune the fit, ensuring a snug hold while minimizing the cover's presence on top.