X220 8x1 LED mounted rear bracket

thingiverse

Hi, take a look at my other designs https://www.thingiverse.com/BuiltBrokenGlued/designs Eachine Wizard X220 Rear LED mount. This design should be printed without supports and at 0.15 mm layer height. I personally printed it at 2.0 mm and had no issues. The mount is not secured vertically; instead, it relies on the rear uprights to slide onto them smoothly. The LED is held in place by two m3x10 screws that secure the LED frame snugly into the slots on the print. The screw holes are 3.10 mm in diameter and feature a flat roof, allowing the screws to dig in securely. If you prefer added security, a small amount of super glue can be used to prevent the screws from coming loose, but I've found this step unnecessary so far.