X-Wing Car

thingiverse

This is a revised version of Clem2k3's X-wing car model, with a few key improvements. One major issue with the original design was the joining block, which wasn't quite large enough to accommodate the front and rear fittings of the X-Wing. To fix this problem, I've included an updated joint block that should fit much more snugly. You may need to tap it into place with a hammer, but it should work out in the end. The new joining block prints in two separate pieces, which can be glued together along with all of the other model components. For added realism, you can use 3mm 3D ink to create the wheel axles. With a little patience and skill, your X-Wing model should turn out looking fantastic. May the power of the Force be with you as you bring this iconic vehicle to life!