X-Wing

thingiverse

A set of models used to make an X-Wing. The parts needed are: xwing_cockpit x 1 xwing_wing x 2 xwing_wing_2 x 2 xwing_spire x 4 xwing_engine x 4 xwing_stand x 1 Assembly is straightforward, there is a small hole on the extremity of the wing for a spire. the wing center (near the large cylinder) has a larger hole for an engine, each wing gets one of each. once all 4 wings are assembled, there are corresponding holes on the hull to slot the wings into. These slots have a wide play so you can orient the wings in either orientation (attack position vs not) when affixing them. Some glue/epoxy is needed for assembly. Personally, I used hot glue, but I imagine other options will work. The tolerances on the pieces is very tight. I prefer that, as it's easier to remove than to add, but be aware you will likely need to remove material when assembling. Also, given the nature of the build you will likely need to print it at about 6x the base size to get the proper detail to resolve.