X-Shot Chaos Orbit Picatinny RAILS

thingiverse

***19 Jul 2022*** Update, fixed some minor tolerances on the "toprear_cover_raised" file, this should eliminate sanding for most prints so it sits flush. Increased the hole diameter to 2.9mm instead of 2.4mm - M3 screws should screw right in with no drilling required now - hence the file "toprear_rail_picatinny 17" is updated too. ***°*°°*°°°**°*°°* Original Description below -_:_: // This is part of the "full upgrade for the Orbit" The other parts are here: Stock: https://www.thingiverse.com/thing:5470581 Handguard: https://www.thingiverse.com/thing:5470584 Speedloading Magazine: https://www.thingiverse.com/thing:5464565 Tactical Grip System: https://www.thingiverse.com/thing:5441314 Picatinny Rails: https://www.thingiverse.com/thing:5430884 Muzzle: https://www.thingiverse.com/thing:5470596 The Orbit Blaster direly requires picatinny rails, so here there are Side rails for left and right, and top mid (if you cut the visor) and backside. The front already has a thingiverse, so I did not design one. Those are covers with rails to glue to and screw the assembly on the Blaster. If you want to use the "midplate" you have to cut the stock visor, see attached picture for where to cut. The Holes are 2.4mm diameter, you might adjust them as you see fit for your screws. You can print anything without supports. I've used 1.2mm printing in ABS & PETG.