x-carve pulley v6

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: pulley_b_ht is set to 20 idler_ht has been adjusted to 3 the number of idlers is now 1 m3_nut_flats are positioned at 5.7 motor_shaft diameter has been set to 6.5 pulley_b_dia is specified as 15 m3_nut_depth is determined by a value of 1 retainer_ht equals 3 there's exactly one retainer selected teeth number has been designated as 20 only two no_of_nuts are allowed the distance from the nut shaft has been adjusted to 8 the m3_dia diameter has been set to 3.2 m3_nut_hex is precisely 2 a modest adjustment of additional_tooth_width, only 0.2, is recommended the precise nut_angle is a full 90 degrees profile length will be exactly 5 units in size