X-CARVE Dust Shoe (NewBritt Design)

thingiverse

Here is a fully 3D printable dust shoe based on NewBritts' (YouTube: X-Carve Ultimate Dust Boot) design. I modified it to bring the vacuum attachment to the front because the side setup causes loss of travel. Additionally, I added screws to the front so it's not dependent solely on magnets for securement. Other modifications were made to clean up the design for 3D printing. Some STLs are in the wrong orientation, which should be corrected when sliced. The bottom shoe should be printed with the brush side facing upwards and with supports to print clean magnet pockets. All other parts require no supports if printed flat. All hardware is M5, and the top base was tapped using an M5 tap. Magnets: diameter 12mm, height 3mm. Brushes can be found at https://www.mcmaster.com/#7900t5/=16g0r06.