X carriage - bottom plate update

thingiverse

Mounting holes for endstop switches have been modified to be 1mm further apart than the original part, a necessary change for accommodating Omron switches. The mounting holes for endstop switches now have a 2.2mm diameter instead of 2mm, designed specifically for use with 2.4mm screws. A conical shape has been added to the space where screwheads are located, reducing material taken from thin arches and allowing for better fitment with screw heads from an aliexpress kit that feature conical heads. The height of the space for endstop switches has been increased to 6.5mm, matching all other switches, which reduces stress on the print and makes it less likely to crack when the switch is pressed in. A modification has been made to the shape of the central ridge to facilitate easier installation of switches with pre-fitted 3-pin female connectors, allowing them to pass through without issue. The thickness of arches over endstops has been increased by 0.4mm, and overall height by 0.3mm. This should still fit properly, but further investigation is warranted. Revised to version 2.1, with the right side arch corrected to have a height of 7.3mm instead of 6.3mm. Additionally, a variant has been added with extra margins (+0.1mm width and height for endstops, +0.05mm diameter for endstop mounting holes). A bonus feature is included: a Y Endstop Holder, featuring endstop switch holes that are 9mm apart and 2.25mm in diameter.