X Carriage 50mm horizontal

thingiverse

50mm horizontal X Carriage with E3D v6 Hot end mount.\nThere is an E3D v6 fan shroud:\nE3D v6 Hot end mount and Fan shroud have caused issues on TinkerCAD not able to upload files. Issues persist even after file size reduction, still fails to upload to TinkerCAD.\nI've almost given up trying to get TinkerCAD to upload a fix.\nhave added two new files { Bigger Blow BLTouch Side E3d v6 Two Fan ring.stl and Bigger Blow Cable Side E3d v6 Two Fan ring.stl }. These files have a deeper air ring design that should allow greater air flow round and through the gap in that ring. This allows for increased airflow using PWM, overcoming maximum limits. These two files have not been tested yet.\nThese two Bigger Blow files required some work before 3D printing.\nIMPORTANT!!! \nThese two files have caused me problems printing, even though they were repaired, they just do not print well for me. It appears to be a definite file issue and not a 3D Printer problem:-\nE3D_v6_Two_fan_left_side.stl\nE3D_v6_Two_fan_right_side.stl\nThe earlier two files did print well and are in use, whether or not having these fans on the PLA print helps is unclear to me.\nHot_End_BLTouch_side.stl\nHot_End_Cable_side.stl\nThis build is based on Techtiptricks E3D V6 Extruder Mount.\nI would like to acknowledge Techtiptricks E3D V6 Extruder Mount.\nThis print is a remix of this.\nhttp://youtube.com/watch?v=t_fsZ7N-CrQ\nand remix of :-https://www.thingiverse.com/thing:1479078\nPlay List on YouTube:-https://www.youtube.com/playlist?list=PLUqt0sTiXUDfYbfrTFH6XhXV4E0Dv2eE6\nPlease note the video blowing test video "E3D v6 Two Fan Ring blowing fan Paper Test" shows an older E3D v6 mounting design:\nThese two files are\nHot_End_BLTouch_side.stl\nand\nHot_End_Cable_side.stl\nBLTouch is used, so called because I use a BLTouch\nHow I Designed This\nTInkerCAD, with numerous problems\n TInkerCAD, with numerous problems