X Belt holder self locking

thingiverse

5th April Update: I revised the block, scaling it down to one-tenth its original size. The new version is v3. Following my upgrade of the X-carriage on my Anet A8, I discovered that the included X-belt holder by itesdahl was oversized for my GT2 belt. During belt tensioning, a tooth would constantly slip out. I found an alternative X-belt holder designed by c0ryp1, which is available at https://www.thingiverse.com/thing:2795893. However, this holder lacked the correct holes to accommodate itesdahl's X-carriage. To address this issue, I used c0ryp1's lock design and quickly created a new block featuring two holes with the precise size required for itesdahl's X-carriage – 50mm apart and 4mm in diameter. For secure attachment of the holder to the carriage, I employed M3 screws accompanied by washers and nuts. A spring was not utilized due to my confidence that it is unnecessary. Please ensure you have a belt tensioner installed prior to utilizing this holder.