X Axis Tronxy p802ma Belt tensioner FOR TOOTHED BEARING - REMIX

thingiverse

If you can't print this, consider ordering it through my 3DHub at: http://3dhubs.com/service/8Bit. This design is made so that you can take a TOOTHED bearing and use that on your belt. It allows for much straighter, better belt alignment with higher accuracy on jerk movements. I used these bearings from Amazon, but any 16 or 20 (20 is less accurate) toothed bearing will work. You'll also need 1 x 30mm M3 screw and 1-3 M3 nuts, depending on your preference. I used 3 nuts, one inside both prongs and 1 outside the screw. This is the exact same back piece as the original design.