X-153 - "Sauce 1" - XL Monster Whoop - 3" Micro Brushless Quadcopter Drone

thingiverse

13.09.2018 - Crucial Upgrade to Camera Mounts - Enhanced Clearance and Adapters Added Note: This mount is thoroughly cleared internally for 20 x 20 mm to ensure a precise fit for the camera. The mount can easily be bent to accommodate any looseness, or you can use thin washers to resolve any issues if encountered. Choosing the Right File: Several files are available, which include: 1. RunCam 19 x 19 Mount - Features M2 holes on each side to mount 19 x 19 cameras or provided adapters. 2. RunCam 19 x 19 Mount - Equipped with M2 slots on each side to mount 19 x 19 cameras or provided adapters. 3. Drop Head RunCam 19 x 19 Mount - Labeled as such and is smaller than the other mounts, allowing for roof mounting. 4. Universal Camera Adapter - By looping a rubber band around the front of the lens, twisting, pulling behind, and over the camera and back onto the lens will secure your FPV camera. This is suitable for Tiny Whoop style cameras and offers adjustable tilt, with clearance for 13.8 mm lenses. 5. Universal Camera Adapter TPU - The same as the above file but with a smaller lens opening. If printed in TPU, it can be pushed fit into your camera, with the mount stretching and gripping it securely. If difficulties arise, carefully and safely cut a small slit to expand the hole. Print Advice: Place the piece on the bed so that when looking directly down, it appears as a C or a U. The print lines should run along the long edge of the piece where the camera bolts in. For the adapter, print vertically with the lock points pointing up off the bed. Files have been updated and included. Separate files can be found at: https://www.thingiverse.com/thing:3098162 real_darKing kindly made and shared an attractive mount to use on my frames. You can check it out at: https://www.thingiverse.com/thing:3094068 Preliminary Upload. Until full instructions are available, follow the X-120 or X-132 for 99% of the way. If you need camera mounts in set increments, find them on the X-132/120. X - 132 - https://www.thingiverse.com/thing:2956351 X -120 - https://www.thingiverse.com/thing:3057883 If using a Magnum Mini Stack (as in the Emax Babyhawk R), you will need to use M2 to M3 adapters. You can mount via the arm holes or by rotating the stack to have one corner facing forward like a Tiny Whoop. Adapters: https://www.thingiverse.com/thing:3093369