X-10 Nstinct icon remote IR34A battery door cover

thingiverse

Just a replacement for a broken battery cover for the X-10 Nstinct remote. This fits the IR34A model. There is another remote called the icon remote, I don't know if that remote uses the same one. Important: This should be printed on it's side. Although it may look nicer to print flat, the latch part will break easily at one of the layers. I printed mine in PETG, as has a little flexibility, and is fairly strong. There is not much flex needed, so PLA may work just fine. I used a Raft and supports. Supports were anything over 70 degrees. The small back tabs could print without supports, but I doubt the latch part would start printing nicely without them.