Wyze Phil for Smaller Printers

thingiverse

This is a remix of Wyze Phil by JKaechler that will allow those of us with smaller printers to print this model in pieces. https://www.thingiverse.com/thing:3390543 From JKaechler: "This is the Matterhackers Phil mascot blown up until a Wyzecam fits in his helmet. Sort of like a Garden Gnome security guard for the 3d printing community. There is a hollow down and out the bottom of his backpack for the USB cable, and holes in his toes for some screws to secure him down if need be. If you make yours from PLA, don't position it in the sunshine. Also, this is not weather resistant, so be careful of placement. Phil in this configuration stands roughly 260mm tall." Print Settings per part: wyze_phil_head: print with the flat side down with tree supports. wyze_phil_body: print with shoes down with tree supports and brim. The Brim will help hold things together until you get above the treads in the shoes. wyze_phil_visor: print with the inside (the part that goes against the camera down with normal supports. If I were to do this again I might do it standing up with a slight angle a raft and tree supports but since none of the insides can be seen the finish was not terribly important to me. connector: print laying flat on sides on a raft with no supports.